BASF nyloflex Combi FI Super Bedienungsanweisung Seite 18

DRYER AND EXPOSURE SETTING
SWITCH ON THIS SECTION PRESSING KEY 1
START keys switch on the corresponding function and recall the setting, except key 9 which
starts or stops the pump showing on DISPLAY 10 the value of the vacuum that has been
reached.
The dryer has a constant heating control, key 5 . It is possible to activate the countdown of
a previously set time for each drawer. This function, only for information, allows the operator
to be sure about the drying time for each plate put in the drawers.
9 working programs are available for the exposure and 9 for the post-exposure; this allows
the operator to work in exposure and post-expoure at the same time using different programs.
To set and recall each program, press P and type the number of the program, from 01 to 09
for the exposure and from 11 to 19 for the post-exposure.
SETTING EXAMPLE
- Press P and type 01 (to set values in the first exposure program)
- Press MEMO + key 11 and type the pre-exposure time in secs., press MEMO
- Press MEMO + key 13 and type the exposure time in min., press MEMO
- Press P , type 11 (to set values in the first post-exposure program)
- Press MEMO + key 15 and type the post-exposure time in min., press MEMO
- Press MEMO + key 17 and type the UV-C time in min., press MEMO
- Press MEMO + key 5 and type the drying temperature in °C, press MEMO
- Press MEMO + key 7 1 and type the drying time in min. for the first drawer, press MEMO
Repeat this operation to set the time in the following drawers.
EACH FUNCTION HAS A DISPLAY SHOWING:
- For the programming, the value that has been set.
- For the process, the countdown.
- The end of the process with the word END.
OTHER PROGRAMS
If, at the end of the day, there are still some plates being dryed, it is possible to have the
heater switched off at the end of the last time set:
press MEMO + key 7 of the drawer not being used and type 999 - press MEMO.
To see how many hours have the lamps been working press P 94.
- DISPLAY 14 will show the data of the exposure lamps.
- DISPLAY 16 will show the data of the post-exposure lamps.
- DISPLAY 18 will show the data of the UVC lamps.
To reset working hours (necessary when lamps are to be changed):
-EXPOSURE: P 981357
-POST-EXPOSURE: P 971357
-UVC: P 961357
1 MAIN SWITCH
2 NUMERICAL KEYBOARD
3
DATA STORAGE
4 PROGRAMS RECALL
5 DRYER HEATING CONTROL
6
TEMPERATURE DISPLAY
7
COUNTDOWN KEY FOR THE
DRYING TIME IN EACH DRAWER
8 TIME COUNTDOWN DISPLAY
9
PUMP SWITCH
10 VACUUM VALUE DISPLAY
11 PRE-EXPOSURE TIME KEY
12
PRE-EXPOSURE TIME DISPLAY
13
EXPOSURE TIME KEY
14 EXPOSURE TIME DISPLAY
15 POST-EXPOSURE TIME KEY
16
POST-EXPOSURE TIME DISPLAY
17 UVC EXPOSURE TIME KEY
18 UVC EXPOSURE TIME DISPLAY
6 5
14 12 10
START
C°
START
min 1
START
2
min
START
min 3
min 4 START
8
7 16 18
9 11 2 3
1 2 3
START
MEMO
bar
4 5 6
P
START
sec
7 8 9 0
START
min
START
min
I
!
uv-c
0
START
min
15 17 13 1
4
17