BASF nyloflex Combi FI Super Bedienungsanweisung Seite 14

L) Setting of step number to clasp the plate:
Clasping of the plate-holding bar is made with special inserts in the chain at intervals
of 230 mm. When a plate has completely entered the washout, it is possible to set a
number of intervals before the LED turn to green, allowing the following plate to enter.
Press P80, type the number of steps, from 1 to 9, press P.
SPECIAL PROGRAMS
The following programs are only for information, it is advisable to use them in presence
of a technician.
P 81: quantity in liters to be discharged when solid contents is over the set %
P 82: time, in seconds, used to discharge one liter of solvent
P 83: solvent charge pump P2 maximum working time, in minutes, (for safety)
P 84: solvent discharge pump P1 maximum working time, in minutes, (for safety)
P 85: solvent spraying time, in seconds, on brush G
P 86: audible signal time at the end of the washout of the plate
P 87: time interval, in minutes, for automatic measurements of solid contents %.
P 88: volume adjustement for solid contents test
P 89: diameter adjustement for solid contents test
P 96 + Key: to set to 0 the number of processed plates
P 99 + Key: to set to 0 all the stored data
13