Valeo THERMO E 200 Einbauanweisung Seite 57

Thermo E 200/320
– Remedy the failure cause and then interrupt the power supply for at
least 5 sec. within the next 2 min.
Purge cycle done:
Failure
(HLO) Acc. to kind of failure
and occurence time
occurs
0
x
2. Generally
– purge cycle 120s (Attention: Reading the flash code 8, the purge
cycle takes place without burner motor)
– interruption of the power supply
– remedy the failure cause
– return the power supply
– switch the heater on
– Now the heater lock-out can be released if the power supply for at
least 5 sec. within the next 2 min is interrupted again.
Purge cycle done:
Acc. to kind of failure
Failure
occurs and occurence time
0
Power supply interruption for example by
– remove the fuse
– disconnect the connector "C" at heater
Release 120s possible
Interrupt the power supply 5 sec.
Remedy
failure
time in sec.
x+120
Release 120s possible
Interrupt the power supply 5 sec.
x
Malfunctions
time
in
sec.
x+120
53