Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MACHINE CONTROL
6.1.8 CRUISE CONTROL SWITCH
The cruise control switch is installed in the machine in dependence on its version.
The cruise control is only in the operation with the ignition switched on. Never switch it off by mere stepping
on the brake pedal as the cruise control function would be kept with the next stepping on the travel pedal
- hazard of an injury is threatening. Use the cruise control at the long and direct travels only.
Before any change of the travel direction switch the cruise control off by the switch.
6.1.9 AUT/MAN SWITCH
The AUT/MAN (AUTOMATIC-MANUAL) switch is installed in the machine in dependence on its version. When it is set to the "MAN" position, it is put
out of the operation and the mowed mass may accumulate in the discharge tunnel. That is why the "MAN" position is only determined for a short-term use
at the finishing of mowing of very small remainders of area. When it is set to the "AUT" position, the function of mowing is automatically switched off at
the fill-up of the grass collecting bin.
Position
Grass collecting bin is full
AUT
NO
AUT
YES
MAN
NO
MAN
YES
6.1.10 RESET SWITCH
The RESET switch is installed in the machine in dependence on its version. It serves for the restoration
of the AUT/MAN function. It is operative after discharging the grass collecting bin.
AUT/MAN
Switch of mowing
switch position
mechanism was
all the time on
AUT
The RESET switch is not operative at any different setting of switches.
6.1.11 SWITCH OF GRASS COLLECTING BIN DUMPING
The switch of the grass collecting bin dumping is installed in the machine in dependence on its version.
The switch has two positions:
-
LIFTING
-
LOWERING
The end positions of the bin in the lifted or normal position are secured with a safety clutch.
At lifting or lowering the bin, keep the switch depressed. As soon as the end position is reached,
release the switch immediately, otherwise a breakdown of the electrical installation is threatening.
6.1.12 BRAKE
When the brake pedal is fully stepped on, the mowing machine is braked to a stop.
Never use the brake simultaneously with the function of the travel -
a damage of the gearbox is threatening.
6.1.13 PARKING LEVER
The parking brake lever has 2 positions. Before shifting the lever into the "B" position,
step on the brake pedal. Lock the lever in the "B" position by turning it round a slight amount.
The disengaging of the parking brake is executed by stepping on the brake pedal,
at this the brake lever pawl is automatically released.
A
B
6.1.14 TRAVEL PEDAL
It controls the drive of wheels and machine travel speed in both
directions.
Forward drive: Step on slowly the pedal with the toe in the "F" direction.
The bigger stepping on the higher speed and vice versa.
Backward drive: Step on slowly the pedal with the heel in the "R" direction.
The bigger stepping on the higher speed and vice versa.
As soon as the pedal is released, it returns automatically into the "N" (neutral) position
and the machine stops. The travel pedal is equipped with a safety switch which will
prevent from starting the engine if the pedal is stepped on.
The change of the drive direction is only possible after the machine stops.
All manuals and user guides at all-guides.com
WARNING !!!
Mowing mechanism
ON
OFF
ON
ON
RESET switch was
depressed
YES
YES
OFF
ON
WARNING !!!
Drive of mowing
mechanism
ON
16
ENGLISH
Werbung
Inhaltsverzeichnis
