Connecting To A Water Source - Stihl RE 90.0 Gebrauchsanleitung

English
6.3.2 Removing the spray gun
2
► Press and hold the locking lever (1).
► Pull out the connector (2).
6.4 Attaching and removing the
spray lance
6.4.1 Attaching the spray lance
2
► Push spray lance (1) into spray gun (2).
► Twist the spray lance (1) until it engages.
► If the spray lance (1) cannot be pushed easily
into the spray gun (2): Grease the gasket on
the spray lance (1) with grease for fittings.
6.4.2 Removing the spray lance
2
1
► Squeeze spray lance (1) and spray gun (2)
together and twist as far as they will go.
► Pull spray lance (1) and spray gun (2) apart.
34
1
1

7 Connecting to a water source

6.5 Attaching and removing the
nozzle
6.5.1 Attaching the Nozzle
2
► Push nozzle (1) onto the spray lance (2).
► Turn the nozzle (1) until it engages
► If the nozzle (1) cannot be pushed easily into
the spray lance (2): Grease the gasket on the
nozzle (1) with grease for fittings.
6.5.2 Removing the nozzle
2
► Press nozzle (1) and spray lance (2) together
and turn until stop.
► Pull nozzle (1) and spray lance (2) apart.
7 Connecting to a water
source
7.1 Connecting the high-pressure
washer to the mains water sup‐
ply
Connecting the water filter
If the high-pressure washer is operated with
sandy water or water from cisterns, a water filter
must be connected to the high-pressure washer.
The water filter filters sand and dirt out of the
water and thus protects the components of the
high-pressure washer from damage.
Depending on the market, the water filter may be
included with the high-pressure washer.
► Unscrew the connector.
1
1
0458-002-9821-B