Screw (+Psw 4 × 50); Pulley (×2); Base Adaptor (×2); Screw (+Psw 6 × 20) - Sony SU-WL450 Installationsinformationen

Screw
(+PSW 6 x 20) 
Pulley 
Soft cloth
4
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV is
installed.
Refer to the Reference Guide supplied with
your TV.
Note
 Subcontract the cable routing in the wall to a
licensed contractor.
 Bundle the connecting cables to prevent stepping
on them before wall mounting.
Installing the TV or LCD
Monitor on the Wall
WARNING
 Two or more persons (three or more persons for
189.3 cm (75 inches) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (except
Egypt).
Two or more persons (three or more persons for
75 inches (189.3 cm) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (Egypt
only).
Screw
(+PSW 6 x 20) 
Spacer
(20 mm) 
Belt 
− 11 (GB) −
1
Lift the TV or LCD Monitor.
• For the location of the Pulleys  to hang
on the Base (20)  or Base Adaptor ,
refer to "Base Adapter  fitting location"
on page 14.
• Make sure that the rear of the TV or LCD
Monitor touches the Base (20)  or Base
Adaptor  when holding the TV or LCD
Monitor.
Note
 Hold the TV or LCD Monitor securely with both
hands.
2
Install the TV or LCD Monitor
onto the Base (20)  or Base
Adaptor .
• Gently slide down the TV or LCD Monitor
and hang the Pulleys  attached to the
rear of the TV or LCD Monitor to the Base
(20)  or Base Adaptor , making sure
to confirm the shape of the holes.
• After installing the TV or LCD Monitor on
the wall, confirm the Pulleys  are firmly
latched into the Base (20)  or Base
Adaptor .
• Release both hands slowly to ensure that
the TV or LCD Monitor does not fall.
 Pulley
GB