Belt (×1); Screw (+Psw 6 × 50); Screw (+Psw 4 × 20); Screw (+Psw 4 × 50) - Sony SU-WL450 Installationsinformationen

Preparing for the Installation
of the TV or LCD Monitor
Note
 Be sure to store the removed screws and unused parts
in a safe place, keeping them away from children.
Except XR-50X94J / 50X93J
1
Attach the Table-Top Stand to
make the TV or LCD Monitor
standing.
• Refer to your TV's or LCD Monitor's Setup
Guide.
2
Remove the screws from the rear
of the TV or LCD Monitor.
3
Attach the Wall-Mount
Attachment
VS
the TV or LCD Monitor) to the
rear of the TV or LCD Monitor (to
make it parallel with the wall).
VS
(supplied with
1.5 N·m
{15 kgf·cm}
− 11 (GB) −
Note
 Be sure to fasten the Wall-Mount Attachment
VS
when attaching them to the TV or LCD
Monitor.
Use only a flat head screwdriver to install the
Wall-Mount Attachment
might result in over torqueing the Wall-Mount
VS
Attachment and damaging the TV or LCD
Monitor.
4
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring
to "Supplied with SU-WL450" in
"Checking the Parts" on page
7.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
If standard mounting (2-a) is selected:
 Belt
If slim mounting (2-b) is selected:
 Belt
VS
. Use of another tool
 Pulley
 Screw
(+PSW 6 × 20)
 Screw
(+PSW 6 × 50)
 Spacer
(60 mm)
 Pulley
 Screw
(+PSW 6 × 20)
 Screw
(+PSW 6 × 20)
 Spacer
(20 mm)
GB