Control Throws; Control Horn And Servo Arm Settings; Finding The Center Of Gravity - Modster Hobby Arrows 2000mm SZD-54 Betriebsanleitung

Manual - SZD-54

Control throws

The suggested control throw setting for the 2000mm SZD-54 are as follows (dual rate setting):
Tips: The maiden flight should always be
flown using low rates, fly the aircraft until
you are familiar with its characteristics prior
to trying high rates. Make sure the aircraft is
flying at a decent altitude and speed prior
to using high rates, as the aircraft will be
sensitive to control inputs with the larger
control surface movements.

Control horn and servo arm settings

1. The table shows the factory settings for the control horns and servo arms. Fly the aircraft at
the factory settings before making changes.
2. After flying, you may adjust the linkage positions for the desired control response.

Finding the center of gravity

Finding the correct center of gravity is critical in ensuring that the aircraft performs in a stable
and responsive manner. Please adjust the weight distribution so the aircraft balances in the
range stated on the diagram.
• Depending on the capacity and weight of
your choosen fligh batteries, move the
battery forward or backward to adjust the
center of gravity.
• If you cannot obtain the recommended CG
by moving the battery to a suitable location,
you can also install a counterweight to
achieve correct CG. However, with the
recommended battery size, a counterweight
is not required. We recommend flying
without unnecessary counterweight.
20
High Rate
Elevator 14mm up / down
Rudder 16mm left / right
Aileron
16mm up / down
Low Rate
10mm up / down
12mm left / right
12mm up / down
www.modster.at