Battery Installation; Receiver Diagram - Modster Hobby Arrows 2000mm SZD-54 Betriebsanleitung

Manual - SZD-54
Linkage rod installation
1. With the elevator servo at its neutral position,
connect the pushrod to the elevator.
Note: connect both servo arm and servo horn the
outer-most holes.
Wingtips installation
1. Install the wingtips onto the wings by sliding
them aft.

Battery installation

1. Remove the battery hatch.
2. Remove the hook & loop tape from the fuselage.
3. Apply the looped surface to the battery.
4. Install the battery into the fuselage- securing it
with the preinstalled battery straps.
Note: The weight of each battery may vary due to
different manufacturing techniques. Move the
battery ore or aft to achieve the optimal center of
gravity.

Receiver diagram

The cables from the servo connector board should be
connected to your receiver in the order shown. Note
that the LEDs can be powered by any spare channel
on the receiver.
Tuck the wire leads into the recessed cavity towards
the rear of the battery hatch.
18 www.modster.at