Herunterladen Inhalt Inhalt Diese Seite drucken

Preflight Check - Modster Hobby Arrows 2000mm SZD-54 Betriebsanleitung

Quelle: modster.at
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Manual - SZD-54

Preflight check

Important ESC and model information:
1. The ESC included with the model has a safe start. If the motor battery is connected to the
ESC and the throttle stick is not in the low throttle or off position, the motor will not start
until the throttle stick is moved to the low throttle or off position. Once the throttle stick is
moved to the low throttle or off position, the motor will emit a series of beeps. Several be-
eps with the same tune means the ESC has detected the cells of the battery. The count of
the beeps equals the cells of the battery. The motor is now armed and will start when the
throttle is moved.
2. The motor and ESC come pre-connected and the motor rotation should be correct. If for
any reason the motor is rotating in the wrong direction, simply reverse two of the three mo-
tor wires to change the direction of rotation.
3. The motor has an optional brake setting. The ESC comes with brake switched off and we
recommend that the model be flown with the brake off. However, the brake could be ac-
cidentally switched on if the motor battery is connected to the ESC while the throttle stick
is set at full throttle. To switch the brake off, move the throttle stick to full throttle and plug
in the motor battery. The motor will beep on time. Move the throttle stick to low throttle or
the off position. The motor is ready to run and the brake will be switched off.
4. Battery Selection and Installation. We recommend the 3S 1300mAh-2200mAh Li-Po batte-
ry. If using another battery, the battery must be at least a 3S 1300mAh-2200mAh battery.
Your battery should be approximately the same capacity, dimension and weight as the 3S
1300mAh-2200mAh Li-Po battery to fit the fuselage without changing the center of gravity
significantly.
Transmitter and model setup
After assembly and prior to your first flight, make sure all control surfaces respond correctly to
your transmitter by referring to the diagram below.
www.modster.at
19

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

289562

Inhaltsverzeichnis