Technical Data Table; Instructions For Installation; Installation; Laws, Technical Rules And Norms - Lotus PCI-94ET Aufstellungs- Und Bedienungsanleitung

MODELS
DIMENSIONS cm
POWER SUPPLY
MAXIMUM ABSORPTION A
MAXIMUM POWER kW
POWER SUPPLY CABLE
The data plate is on the front (see diagram in electric connection item) and has all the data necessary for the connection.
When fitting, the appliance must be leveled using a spirit level; slight differences of level can be adjusted by screwing
or unscrewing the adjustable feet. The main switch or the socket must be near the appliance and easily accessible.
It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed
near walls, dividing panels, kitchen furniture, decorative finishes, etc. , these should be in flameproof material;
otherwise it is necessary to cover them with non-flammable material.
Above all, it is necessary to ensure that fire prevention standards are observed.
Always comply with the following points during installation:
- Ensure that mains voltage complies with the voltage indicated on the specification table of the
appliance
- All electrical installations must comply with local standards. All standards issued by national electrical authorities
must be complied with.
- When circuit breakers are used, they must be suitable for a minimum of 30 mA.
- Avoid obstruction of air intakes or outlets with objects (fabric, walls, etc).
- Keep hot air off of the induction appliance (for example when several appliances are next to one another, or behind one
another, or when an appliance is separated by a separate air duct.
- The induction appliance must not be placed near or on hot surfaces.
-The appliance is equipped with a filter. Regardless of this filter, make sure that grease from other
activities do not get onto the induction appliance (for example from nearby fryers or hot plates).
-The temperature of input air must be less than +35°C.
- Personnel that use the appliance must ensure that installation, maintenance and checks are carried out only by qualified
staff.
Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the
disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at
least 3 mm.
Installation must be carried out observing the following norms:
- Safety prescription in force
- Installation prescription, norms in force.
The appliance is supplied without the connection cable. To install the power supply cable, proceed as follows:
?? Disconnect the power supply.
?? Remove the bottom panel
?? Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
?? Block the cable with the cable blocker, and reassemble the bottom panel. The earth wire must be longer than the
others so that if the cable blocker should break, it will disconnect after the tension wires.
GB

TECHNICAL DATA TABLE

PCI-94ET PCIT-94ET
40x90x90 40x90x29
400V/3 400V/3
50/60Hz 50/60Hz
14,4 A 14,4 A
10 kW 10 kW
4x1,5 mm² 4x1,5 mm²

INSTRUCTIONS FOR INSTALLATION

INSTALLATION

LAWS, TECHNICAL RULES AND NORMS

ELECTRIC CONNECTION

IE
PCI-98ET PCIT-98ET
80x90x90 80x90x29
400V/3 400V/3
50/60Hz 50/60Hz
29 A 29 A
20 kW 20 kW
4x4mm² 4x4mm²
29
PCIW-94ET PCIWT-94ET
40x90x90 40x90x29
400V/3 400V/3 50/60Hz
50/60Hz
7,2 A 7,2 A
5 kW 5 kW
4x1,5 mm² 4x1,5 mm²