Philips AquaTrio Cordless 9000-Serie Bedienungsanleitung Seite 42

English
44
Problem
Water drips out of the
appliance after it is switched
off.
I cannot remove the
microfiber brushes.
I cannot move the appliance
forward or backward.
The appliance has a lower
suction power than usual.
Possible cause
The appliance leaves a puddle
on the floor because you did
not move it while switching it
off. This is normal.
The appliance is dripping when
carrying it over the floor
(holding it in the air).
Water leaks from the clean
water tank because you
overfilled the clean water tank.
There is a crack in one of the
tanks.
Hair and/or dirt is entangled in
the microfiber brushes.
One or more wheels may be
blocked by a small object.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The mesh in the dirty water
tank was not dry enough
before being used again.
Hair entanglement on the
microfiber brushes.
The dirty water tank is not
placed correctly.
Solution
of detergent (see 'Using the Vacuum &
Mop set-up').
You can reduce the size of the puddle by
moving the appliance while switching it off.
While cleaning, do not lift the AquaSpin
nozzle from the floor, as this leaves water
traces. Only move forwards and backwards.
Do not fill the clean water tank beyond the
MAX indication. If you do, water may spill
from the clean water tank when you fasten
the cap (see 'Using the Vacuum & Mop set-
up').
If one of the tanks is damaged, take it to a
Philips service center or contact the
Consumer Care Center.
Use the cleaning brush handle to remove
the microfiber brushes from the AquaSpin
nozzle. Remove entangled hair or dirt (see
'Cleaning the AquaSpin nozzle'). If it is
difficult to pull the brushes out, you can
give them a push from below the AquaSpin
nozzle.
Switch off the appliance and remove the
nozzle. Then check the small and the big
wheels for blockage. Remove any object
that could block the wheel(s). Put the
appliance upright again and resume
cleaning.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Clean and dry the dirty water tank.
Switch the appliance off and remove the
hair from the microfiber brushes (see
'Cleaning the AquaSpin nozzle').
Place the dirty water tank into the
appliance properly (see 'AUTOCLEAN after
every use'). It is closed correctly when you
can hear a 'click' sound.