English
26
Cleaning the After-Clean tray
Cleaning the AquaSpin nozzle
23 To allow the microfiber brushes to dry, place the open ends of the brushes on
the designated holders of the After-Clean & Storage station.
Note: Drying can take approximately 24 hours.
If the After-Clean tray gets dirty, you can clean it by following the steps below.
1 Remove the After-Clean tray from the storage station.
2 Rinse the After-Clean tray under the tap and let it dry before placing it back in
the Storage station.
3 Make sure to always put the After-Clean tray back in the Storage station. The
After-Clean tray is essential to perform the AUTOCLEAN correctly.
1 Turn the microfiber brushes counterclockwise (1) and remove them from the
AquaSpin nozzle (2).