Philips AquaTrio Cordless 9000-Serie Bedienungsanleitung Seite 13

Vacuuming soft and hard floors
Using the Vacuum only set-up
-
If you want to add a liquid floor cleaner other than XV1792 Philips Floor
Cleaner to the water in the clean water tank, make sure that you use a low-
foaming or non-foaming liquid floor cleaner that can be diluted in water like
XV1792 Philips Floor Cleaner.
-
As the clean water tank has a capacity of 400ml, you only have to add a few
drops (max 10ml) of liquid floor cleaner to the water.
-
If you use the Vacuum & Mop set-up on linoleum floors, only do so on
linoleum floors that are properly affixed to prevent linoleum from being
drawn into the AquaSpin nozzle.
-
Do not use the Vacuum & Mop set-up to clean carpets.
-
If you move/lift the appliance over a carpet or rug when it is switched off,
wastewater droplets may end up on your carpet or rug.
-
Do not push the appliance over the floor grilles of convector heaters. As the
appliance cannot pick up water that comes out of the nozzle when you move
it over the grille, water ends up at the bottom of the convector pit.
-
While cleaning, do not lift the AquaSpin nozzle from the floor or move the
AquaSpin nozzle sideways, as this leaves water traces. Only move forwards
and backwards.
Note: The operating time depends on the power level used during cleaning.
1 To vacuum soft or hard floors, attach the 3-in-1 handheld to the dust bucket
('click').
Caution: Do not attach the 3-in-1 handheld to the dust bucket without
the filter case being inserted in the dust bucket.
English
15