Philips AquaTrio Cordless 9000-Serie Bedienungsanleitung Seite 40

English
42
Problem
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
The appliance does not clean
as well as it used to.
Possible cause
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have moved the appliance
across a threshold while it was
switched on.
You lifted the appliance up
from the floor immediately
after you switched it off.
The wheels are blocked.
The clean water tank is empty.
The water strips are blocked.
Solution
that does not help, you can try to carefully
open the holes with a needle.
If you have checked the above and there is
still no water on the floor, take the
appliance to a Philips service center or
contact the Consumer Care Center.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Place the dirty water tank into the
appliance properly (see 'AUTOCLEAN after
every use'). It is closed correctly when you
can hear a 'click' sound.
Only move the appliance forwards and
backwards (see 'Usage restrictions').
Try to make less strong turns with the
appliance (see 'Usage restrictions').
Make sure the microfiber brushes stay in
contact with the floor. Make sure the
appliance is switched on before you pull it
over a threshold to prevent water traces on
the floor or to prevent water from
splashing from the AquaSpin nozzle (see
'Usage restrictions').
After you switch off the appliance, move it
forwards and backwards a few times to
remove the liquid that is present between
the two microfiber brushes. If you switch
off the appliance and lift it up immediately
afterwards, the water that was present
between the brushes leaves a trace of
water on the floor (see 'Usage restrictions').
Check the condition of the wheels. Remove
the dirt that blocks the wheels.
Refill the clean water tank (see 'Using the
Vacuum & Mop set-up').
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the water strips are partially or