Setting - Dold SAFEMASTER BH 5904.02/00MF2 Betriebsanleitung

Setting

SW. 10: Selection of operating mode
Valve status sensor
0 S21-S22 : NC, S23-S24: NC
1 S21-S22 : NO, S23-S24: NC
2 S21-S22 : NO, S23-S24: NO
3 S21-S22 : NC, S23-S24: NC
4 S21-S22 : NO, S23-S24: NC
5 S21-S22 : NO, S23-S24: NO
6 S21-S22 : NC, S23-S24: NC
7 S21-S22 : NO, S23-S24: NC
8 S21-S22 : NO, S23-S24: NO
9 not allowed
Plate
The setting of the function of the BH 5904 is done with 4 rotational switches
located behind the front plate shown in the picture. The switches on the left
select the function on processor 1 and the switches on the right of processor
2. For both processors the setting must be the same.
Example for setup:
Function to be selected: status sensor on valve is C/O contact,
1 valve test per machine cycle, max. 1 s.
Set both upper switches to 5
Set both lower switches to 1
Time in which the valve has to react
SW 1 0
(s) 0.5
Valve monitoring mode
1 test per machine cyclic
Continuous monitoring of the valve
20
ch1 ch2
6 9 6 9
1
3 0 3 0
6 9 6 9
10
3 0 3 0
Inside view
1 2 3 4
0.61 0.72 0.83 0.94
Contact reinforcement
Without contact reinforcement
With contact reinforcement
5 6 7 8
1.05 1.16 1.27 1.38
BH 5904.02/00MF2 / 26.01.21 en / 306A
9
1.49