Husqvarna FS 600 E Bedienungsanweisung Seite 20

2. If an external water hose is used, push the water
valve to let the water on or off.
3. Turn the water tap to adjust the water supply.
4. Do a check of the water flow. If it is necessary,
adjust the water supply.
5. Start the motor. Refer to
page 18 .
20
To start the product on
6. Slowly turn the cutting depth wheel counterclockwise
to lower the cutting blade.
7. Make a cut as a guide, approximately 20-30 mm.
8. Do cut increments of 50 mm until you get the
necessary depth. Push the lever to lock the cutting
depth wheel.
9. Adjust the water supply when you operate the
product. Each side of the cutting blade must have
sufficient supply of water to cool down the cutting
blade. The water also prevents dust buildup.
10. Cut only in a line, align the cutting blade with the
marks.
11. Slowly push the product forward and make sure that
the pointer and the cutting blade are aligned with the
marks.
CAUTION:
from side to side to align the cutting
blade with the marks.
Do not move the product
1620 - 003 - 28.02.2022