Water Supply - Husqvarna FS 600 E Bedienungsanweisung

To use the correct working technique
• Stay away from the blade path while the motor is on.
The correct operator position is behind the handles
with both hands on the handles.
• Examine the cutting blade frequently for cracks and
broken parts during the work day. Do not use a
damaged cutting blade.
WARNING:
disconnect the power plug before you
examine the cutting blade.
• Do not grind with the side of the cutting blade. The
cutting blade can break and cause injury to the
operator or bystanders. Only use the cutting edge.
• Do not bend or twist the cutting blade in the cut.
• Make sure that the cutting blade moves freely and
does not catch in the cut.

Water supply

The cutting blade must have sufficient supply of water
during operation. Use water from the water tank on the
product or from an external water hose. Refer to
the water tank on page 17 and To connect the external
water supply on page 18 .
To fill the water tank
WARNING:
Do not put other liquids in the water tank.
WARNING:
blade is slightly above the ground when you
turn the water tap to adjust the water.
1620 - 003 - 28.02.2022
Stop the motor and
To fill
Only put water in the tank.
Make sure that the cutting
1. Close the water tap and disconnect the water hose.
2. Remove the water tank strap (A) and the water tank
(B). Do not spill water on the product. Move the
water tank away to a safe distance from the product.
A
3. Remove the water tank lid (C) and fill the water tank
with water.
4. Install the water tank lid.
5. Install the water tank.
6. Install the water tank strap and connect the water
hose.
B
C
17