Before You Fly - Gin Gliders Switch2 Bedienungsanleitung

BEFORE YOU FLY

Make sure your dealer has checked the harness for
completeness and basic settings. Your harness must
be assembled by a suitably qualified paragliding
professional, for example, your instructor.
Gin Gliders recommends that assembly be carried
out in the following order. If you are in any doubt
whatsoever about this procedure, please seek
professional advice from your instructor, GIN dealer
1
3
or importer.
4
2
INSTALLING THE SPEED SYSTEM
Assemble the speed system from top to bottom.
Pass the chord along the inside of the harness
and route it through the Speed pulley (1). From the
pulley, route the chord through the metal ring at the
bottom edge of the seat (2). From the metal ring,
to the plastic opening (3). Connect the chord to the
speedbar using a secure knot (4).
1 2 3 4
CAUTION:
Make sure that the speed system is not
too short. The front risers of your paraglider must not be
pulled down in normal (unaccelerated) flight.
5