Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTING THE RESCUE BRIDLE
To connect a rescue to your harness we recommend using a GIN Rescue Carabiner. If you choose to use
di erent type of connector, it should be rated at least 9 times the maximum weight. For example, our
recommended 7mm Stainless Steel screw-gate maillon (square) connector has a minimum breaking load of
28kN (2855 Kgf). It is the pilot's responsibility to check the compatibility of the rescue system and ensure that
it is installed properly.
Be sure to inspect your connector during normal maintenance and safety checks. Replace it whenever
there are any signs of wear and check your rescue system with a professional after any deployment. We
recommend that you cover the connection using the Maillon rapid cover to prevent excess friction. Rubber-
bands should also be used to secure the attachment and prevent excess friction.
Recommended by GIN: 7mm stainless steel screw-gate maillon
7mm square maillon
Breaking load: 28kN
Maillon connection
(Recommended by Gin Gliders)
WARNING:
When connecting the rescue bridle be
sure to secure the connection using tape, rubber bands
or heat shrink wrap. If the bridles are not secure they
may burn or cut from excess friction.
IMPORTANT:
Be sure to connect both rescue
bridles to the rescue.
11
Werbung
Inhaltsverzeichnis
