Commissioning; Operation; Cleaning - CMi C-WIS-2000/230 H Originalbetriebsanleitung

Fitting the abrading disc
DANGER! Risk of injury! Never use dam-
aged abrading discs. Always check the
abrading disc for cracks or other damage
before fitting it.
Use only abrading discs whose permitted
rotational speed is at least as high as the
idling speed of the appliance (► Technical
data – p. 39).
WARNING! Risk of injury! The permitted
diameter for the abrading disc must always
be complied with (► Technical data – p. 39).
CAUTION! Risk of injury! Use only abrad-
ing discs which are permitted for the material
being worked with.
► P. 3, item 3
– Press the spindle locking button on the top of the
tool and keep it pressed.
– Unscrew flange nut (8).
– Place the abrading disc onto the spindle. Comply
with the required installation position of the
abrading disc.
– Place the flange nut onto the spindle. Note the
installation position of the flange nut:
1. Flange pointing away from abrading disc: for thin
discs such as cutting discs.
2. Flange pointing towards abrading disc: for thicker
discs such as abrading discs.
– Tighten the flange nut using the face pin wrench
provided while pressing the spindle locking but-
ton.

Commissioning

Adjusting the protective bonnet
WARNING! Risk of injury! The device is
designed for grinding. If the device is to be
used for separating, a special protective hood
must be used.
► P. 3, item 1
The protective hood must be adjusted so that it pre-
vents sparks and particles from being thrown in the
direction of the user.
– Loosen bolt (6).
– Adjusting the protective hood
– Retighten bolt (6).

Operation

DANGER! Risk of injury! Let the appliance
idle for a few seconds before use. When
vibrations start to occur, replace the abrading
disc immediately.
WARNING! Risk of injury! The appliance
must be used only with the additional hand
grip fitted and the protective hood correctly
adjusted.
Check before switching on!
Check the safe condition of the appliance:
– Check it for visual defects.
– Check that all parts of the machine have been
securely fitted.
Switching on/off
WARNING! Risk of injury! After switching
off, the appliance continues to run on for a
few seconds. Wait until the abrading disc has
come to a stop before laying the appliance
down.
Note: In case of a loss of power, an under-
voltage relay is triggered. This prevents the
product from restarting by itself as soon as
the power is restored.
To switch on again the product must be
turned off at the main switch and then turned
back on.
► P. 4, item 4
– Push turn-on lock (2) towards the front and hold;
press on-off switch (1).
– Switching off: Release On-Off switch (1).
Tips on use
DANGER! Risk of injury! Never use cutting
discs for abrading.
CAUTION! Risk of injury! The abrading
disc and work piece become very hot during
use. Let the abrading disc and work piece
cool down completely before touching them.
WARNING! Risk of injury! Always grind
with the specified surfaces:
• Cutting discs: Peripheral surface;
• Grinding disc, grinding wheel: Side sur-
face.
CAUTION! Risk of injury! The abrading
disc and work piece become very hot during
use. Let the abrading disc and work piece
cool down completely before touching them.
• Always clamp the work piece firmly.
• Never tilt the appliance when cutting materials.
• Never apply excess pressure to the appliance.

Cleaning

Overview of cleaning
Regularly, depending on conditions of use
What?
Remove all dust from the
ventilation slits of the mo-
tor.
GB
How?
Use a vacuum cleaner or
a brush.
37