Pb (Lead-Acid) Batteries - Charging / Discharging - CS-Electronic X2 charger Bedienungsanleitung

Additional information to the different programs:
While charging or discharging you can display additional infor-
mation: To see the basic settings and information regarding the
charger, press the -DEC/+INC-keys. When pressing the +INC-key.
Information of the connected battery is displayed, for example the
voltage of each cell when charging in the balancer program.
Attention: Please check that the basic setup of the charger has
already been done and that the battery type correspond to the
selected charging program!
13. Pb (Lead-Acid) Batteries – Charging / Discharging
Pb-batteries are completely different compared with the other battery-types and can only be
charged with this program. You can charge Pb-batteries with a nominal voltage of 2.0 to 20 V.
Pb-batteries are charged with low currents (normally 1/10 of the nominal capacity). An acid-
battery with a capacity of 2.0 Ah (respectively 2000 mAh) should be charged with 1/10 of the
capacity = 0,2 A or 200 mA.
Select with the Batt.Type-key „PROGRAM SELECT Pb Batt" and confirm
it with the Enter-key. Now select the program you need with the
-DEC/+INC-keys.
Charging (Pb CHARGE)
Discharging (Pb DISCHARGE)
You confirm the program with the enter-key and by pressing the enter-
key again, the charge current is flashing. Now set the charge current
with the -DEC/+INC-keys according to the manufacturer's indication.
The values are saved with another pressing of the start/enter-key.
Now you have to set the flashing information displayed on the right
side according to the voltage of the Pb-battery and confirm it with the
enter-key.
When discharging, you have to enter the cell end voltage according to
the manufacturer's indication. Normally it is 1.75 V per cell and you
should not underrun this voltage. To give you an idea the additional information
of the number of cells can be helpful like 3.5V(2S) for 2 cells or 5.25V(3S) for 3 cells. Please refer
to the safety notes.
If you now press the start/enter-key for more than 3 seconds, the selected process.
To interrupt or to break off the charging process press the Batt.Type/Stop-key.
The completion of the charging process is shown by a flashing
"Full" in the display.
Additional information to the different programs: While charging
or discharging you can display additional information: To see the
basic settings and information regarding the charger, press the
-DEC/+INC-keys. When pressing the +INC-key. Information of the
connected battery is displayed, for example the voltage of each
cell when charging in the balancer program.
Attention: Please check that the basic setup of the charger has
already been done and that the battery type correspond to the
selected charging program!
Battery
Carge
type
current
Voltage
Selected Supplied
program capacity
Charging time
Battery Charge
type current
Voltage
Selected Supplied
program capacity
Charging time
15