Safety Notes - CS-Electronic X2 charger Bedienungsanleitung

20. Safety Notes

These warnings and safety notes are particularly important. Please follow the instructions for
maximum safety, otherwise the charger and the battery can be damaged or at worst it can cause
a fire.
Never leave the charger unattended when it is connected to its power supply. If any malfunction
is found, terminate the process at once and refer to the operation manual.
Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibration.
This charger and the battery should be put on a heat-resistant, noninflammable and nonconduc-
tive surface. Never place them on a car seat, carpet or similar. Keep all the inflammable volatile
materials away from operating area.
Make sure you know the specifications of the battery to be charged or discharged to ensure it
meets the requirements of this charger. If the program is set up incorrectly, the battery and
charger may be damaged. It can cause fire or explosion due to overcharging. This warranty is not
valid for any damage or subsequent damage arising as a result of a misuse or failure to observe
the procedures written in this manual.
To avoid short circuit between the charge lead always connect the charge cable to the charger
first, then connect the battery. Reverse the sequence when disconnecting.
Do not connect more than one battery pack to this charger at any one time.
Never attempt to charge or discharge the following types of batteries:
A battery pack which consists of different types of cells (including different manufacturers)
A battery that is already fully charged or just slightly discharged.
Non-rechargeable batteries (Explosion hazard).
Batteries that require a different charge technique from NiCd, NiMh, LiPo or Gel cell (Pb, Lead
acid).
A faulty or damaged battery.
A battery fitted with an integral charge circuit or a protection circuit.
Batteries installed in a device or which are electrically linked to other components.
Batteries that are not expressly stated by the manufacturer to be suitable for the currents the
charger delivers during the charge process.
28