Maintenance And Care; Spare Parts - Kärcher K 3.97 M Originalbetriebsanleitung

Maintenance and care

Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Care
Prior to longer periods of storage, e.g. in
the winter:
 Remove filter from suction hose for de-
tergent and clean under running water.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
Maintenance
The appliance is maintenance-free.

Spare parts

Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.
Troubleshooting
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Appliance is not running
 Pull on the lever of the trigger gun; the
device will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
All manuals and user guides at all-guides.com
Pressure does not build up in the appli-
ance
 Check setting at the spray lance.
 Appliance ventilation: Switch the appli-
 Check the water supply.
 Pull out the sieve in the water connec-
Appliance does not start, motor hums
Cause: Voltage reduction due to weak
mains supply or when using an extension
cable.
 When switching on, first pull the lever of
Strong pressure fluctuations
 Clean high-pressure nozzle: Remove
 Check water flow quantity.
Appliance is leaking
 Slight leakage from the appliance pump
No detergent infeed
 Use spray lance with pressure regula-
 Clean the detergent suction hose filter.
 Check the detergent suction hose for
- 7
EN
ance on with the high-pressure hose
detached and operate (max. 2 minutes)
until the water exits the high-pressure
connection without bubbles. Switch off
appliance and reconnect high-pressure
hose.
tion using flat-nose pliers and clean un-
der running water.
the trigger gun and then switch the ap-
pliance switch to "I/ON".
dirt and debris from the nozzle bore, us-
ing a needle and rinse through with wa-
ter from the front.
is normal. If the leakage increases con-
tact the authorized customer service.
tion (Vario Power).
Turn the spray lance to "Mix" position.
kinks.
17