Working Behaviour And Working Technique (06/09); Maintenance And Care - AL-KO GT 2000 Betriebsanleitung

Working behaviour and working technique (06/09)

7 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (06/09)
WARNING!
Increased risk of falling
There is a greater risk of
falling if work is carried out
from an elevated position
(e.g. ladder).
■
always work with the
appliance from the
ground and make sure
that you are standing
securely.
■
Heed the safety instruc-
tions.
■
Cut the hedge regularly and only at the per-
mitted times.
■
Only cut off the thin branches and new
growth on the surface of the hedge; do not
cut too deep.
■
Always cut the two sides of a hedge first, fol-
lowed by the top. This prevents cut material
from falling into areas that you have not yet
trimmed.
■
Hedges should always be trimmed into a
trapezoidal shape (tapering toward the top).
This prevents the leaves on the lower
branches from being shaded out (09).
■
The integrated spirit level (06) facilitates a
level cut.
■
Make sure the motor is stopped before you
remove any cuttings.
■
When leaving/transporting the appliance:
■
Switch off the appliance.
■
Fit the protective cover.
■
Remove the battery.
■
After use, remove the battery and check the
appliance for damage.
442178_a

8 MAINTENANCE AND CARE

WARNING!
Danger of cutting injur-
ies
Danger of cutting injuries
when reaching into sharp-
edged, moving appliance
parts and into cutting tools.
■
Before maintenance,
care and cleaning work,
always switch off the
appliance. Remove the
rechargeable battery.
■
Always wear protective
gloves during mainten-
ance, care and cleaning
work.
NOTE
Repair work is only allowed to be carried
out by expert workshops or our AL-KO
service centres.
■
Do not get the appliance wet or expose it to
moisture.
■
After each use, clean the housing and cutting
blades with a brush or cloth. Do not use wa-
ter and/or aggressive cleaning agents or
solvents - risk of corrosion and damage to
the plastic parts.
■
Remove the battery and check for damage
after each use.
■
Clean the cutting blade and spray with rust-
proofing oil.
■
Regularly check the cutting blade. Contact an
AL-KO service centre under the following cir-
cumstances:
■
Defective cutting blade
■
Blunt cutting blade
■
Excessive wear
49