Overview Of The Device - Kärcher HDS 1000 BE Bedienungsanleitung

● Do not touch any hot parts such as the muffler, cylin-
der or cooling fins.
● Never bring your hands and feet close to rotating
parts.
● Never operate the device in confined spaces.
● Do not use unsuitable fuels as they can be danger-
ous.
General safety instructions
The following safety instructions apply to the device:
● Observe the respectively applicable national regula-
tions for liquid jet cleaners.
● Observe the respectively applicable national acci-
dent prevention regulations. Liquid jet cleaners must
be tested regularly and the results of the test record-
ed in writing.
● Note that the heating system in the device is classi-
fied as a furnace. Furnaces must be inspected reg-
ularly according to the applicable national
regulations.
● No modifications may be made to the device or ac-
cessories.
High-pressure hose
The following safety instructions apply to the high-pres-
sure hose:
● Use only original high-pressure hoses.
● The high-pressure hose and the spray unit must be
suitable for use at the maximum operating pressure
specified in the technical data.
● Avoid contact with aggressive chemicals.
● Inspect the high-pressure hose daily.
Do not continue using kinked hoses. Do not contin-
ue using the high-pressure hose if the outer wire
mesh layer is visible.
● Do not continue using a high-pressure hose with a
damaged thread.
● Lay the high-pressure hose so that it cannot be driv-
en over or presents a tripping hazard to persons.
● A hose that has been driven over, kinked or subject-
ed to impacts may no longer be used, even if no
damage is visible.
● Store the high-pressure hose in a manner avoiding
mechanical stresses on the hose.

Overview of the device

Description of the device
Illustration A
Illustration B
Manual starter
1
Electric starter
2
Fuel tank
3
Pressure gauge
4
Battery
5
High-pressure nozzle
6
EASY!Lock spray lance
7
EASY!Force high-pressure gun
8
EASY!Lock high-pressure hose
9
EASY!Lock high-pressure connection
10
Fuel tank
11
Water connection with sieve
12
16
Pressure/quantity regulation
13
Pressure tank
14
Fuel pump with fuel filter
15
Burner blower
16
Electrical box
17
Oil sight glass
18
Safety valve
19
Burner cover
20
Booster heater
21
Spark plug connector
22
Burner sight glass
23
Nozzle holder
24
Float container
25
Softener tank
26
Solenoid valve
27
Water shortage safeguard
28
Sieve in the water shortage safeguard
29
Pressure switch
30
Oil filler
31
High-pressure pump
32
Type plate
33
Oil drain plug (motor)
34
Oil dipstick (motor)
35
Detergent suction hose with filter
36
Oil drain plug (pump)
37
Safety lever
38
Trigger
39
Safety latch of the high-pressure gun
40
Illustration C
Power switch
1
Fuel indicator light
2
Liquid softener indicator light
3
Detergent dosing valve
4
Illustration D
Key switch for electric starter
1
"Ignition on" indicator light
2
English
Control panel