Wear And Spare Parts; Customer Service By The Manufacturer; Repairs; Decommissioning, Storage And Disposal - HEYLO DS 65 T Betriebsanleitung

Oil heater DS 65 T
f) Tighten the adjusting screw and mount the
housing cover.
See also
 Technical data and factory settings
18.4

Wear and spare parts

Spare parts must meet the technical requirements
specified by HEYLO. HEYLO original spare parts
must meet stringent requirements.
HEYLO assumes no warranty for damage caused by
the use of spare parts from other manufacturers.
To order wear and spare parts, please contact your
dealer or HEYLO directly, providing the following
information:
– Device type
– Serial number,
– Designation of the component
– Quantity
– Shipping method
See also
 Contact to HEYLO GmbH
18.5 Customer service by the
manufacturer
HEYLO recommends taking out a maintenance con-
tract with the HEYLO Service Department.
See also
 Contact to HEYLO GmbH
19

Repairs

This section describes which repair tasks can be
performed by whom.
NOTICE
During the warranty period, all repairs must be per-
formed by persons authorised by the manufacturer.
For repair by HEYLO, please download the repair
request form from the "Service" section of the
HEYLO website.
Repair by device owner
After the warranty period has elapsed, certain repair
can be carried out by the device owner, provided he
or she has the necessary skills. HEYLO shall not be
liable for damage caused by such repairs.
If you have any questions about repairs, contact the
HEYLO service department or your dealer.
38 / 40
[ 39]
[ 24]
[ 24]
See also
 Contact to HEYLO GmbH
20

Decommissioning,

storage and disposal
The following principles apply for the decommission-
ing, storage and disposal of the device:
These tasks may only be carried out by trained and
authorized specialists.
DANGER
Danger to life due to electric shock
Touching electrically live parts can be fatal.
a) Switch off the device and pull out the mains
plug.
20.1 Decommissioning
Temporary decommissioning
a) Switch off the device at the device switch and
let the cooling time elapse.
b) Disconnect the power plug.
c) Empty the fuel tank and dispose of the fuel ac-
cording to the statutory regulations.
d) Clean the device (see Checking and cleaning
the device [ 35]).
 The device has now been temporarily decom-
missioned.
Final decommissioning
✓ Carry out all the steps needed for temporary
decommissioning.
a) Disconnect all the incoming and outgoing lines
(power supply lines).
 You have now taken the device permanently out
of service.
See also
 Contact to HEYLO GmbH
20.2

Storing the device

a) Before putting the device in storage, run it brief-
ly in heating mode with winter diesel to fill the
pipes with a frost-proof fuel.
b) Store the device in a dry place where it is pro-
tected against frost. Observe the prescribed
storage temperature range (see Technical data
and factory settings [
[ 24]
[ 24]
39]).
EN