Technical Data; Unpacking; Before Commissioning - Scheppach 5911902903 Original Bedienungsanleitung

- if the machine starts to vibrate unusually strongly
(inspect immediately)
Corrective maintenance instructions
Switch off the motor prior to cleaning, repairing, in-
specting or adjusting the machine and ensure that all
parts in motion have been stopped.
Disconnect the ignition cable and position the cable
away from the spark plug in order to prevent accidental
starting.
Have the machine repaired by qualified personnel
using only original spare parts. This ensures that the
safety of the machine is upheld.

6. Technical data

Type of engine
Displacement
Max. motor perfor-
mance
Rotation speed
Fuel
Tank contents
Engine oil
Spark plug
Oil/tank capacity
Depth setting
Working width of
Number of blades
Blade Ø
Collection bag capacity
Weight
Technical changes reserved!
Information about noise level measured in accordance
with applicable standards:
Sound pressure L
pA
Sound pressure L
wA
Measurement uncertainty K
Wear hearing protection.
Excessive noise can result in a loss of hearing.
30 | GB
Single-cylinder / 4-stroke
212 cm³
4.0 kW
3400 min
-1
Unleaded petrol
3.6 l
10W 30 / SAE 30
F7TC
0.6 l
+5 / -15
400 mm
18
165
45L
38 kg
= 85.9 dB(A)
= 101.2 dB(A)
= = 3.43 dB(A)
pA
www.scheppach.com
Vibration:
Vibration A (left/right)
hv
Measurement uncertainty K
Keep the noise level and vibration to a minimum!
• Only use devices which are free of defects.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
• Wear gloves.

7. Unpacking

m ATTENTION!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.

8. Before commissioning

Assembly
m Attention!
Always make sure the device is fully assembled
before commissioning!
Guide bar assembly (Fig. 3 - 9)
• Fit the lower push bar (4) as shown in Figures 3 + 4.
Affix the bar with four hexagonal screws (E, F), two
washers (G), two plastic star grip nuts (5) and two
locknuts (D).
• Connect the upper push bar (handle) (1) to the lower
push bar (4). To do so, use two plastic star grip nuts
(5) with the corresponding hexagonal screws (F)
and washers (G) (Fig. 5 + 6)
• Fit the draw wire holder (B) on the right side of the
steering bar as shown in Fig. 7.
• Fasten the cables to the push bar with the two cable
clamps (A). (Fig. 8 + 9)
= 7.03 m/s²
= = 1.5 m/s²
pA