Recording Samples; Scratch Effects; Stutter Effects - Omnitronic TMC-2 MK2 Bedienungsanleitung

8.3 Recording samples

The title that is monitored serves for recording a sample. Thus, during a live mix, you can play a title on the
other deck and monitor the sampler operation via headphones without the audience listening in.
• The sampler mode is not controlled by the controller but with the mouse.
• With Virtual DJ LE, recorded samples are only available for the duration of a session.
1
Enter the sampler mode in Virtual DJ by clicking on the [SAMPLER] tab
in the center section.
2
Start playing the title and click  [REC] at the appropriate time to begin
recording the sample. The field is highlighted in red.
3
If the title is in a loop, the loop is captured as the sample when clicking
 [REC] (without red indication). Otherwise, click  [REC] a second
time to stop the recording. The red indication extinguishes.
4
You can set the volume of the sampled with the corresponding volume
fader.
5
To check the sample afterwards, click [PLAY]. The field's color changes
into green and you see the playback bar below fill gradually.
6
By clicking [ ] you can select if the sample is played once or as a
continuous loop. In loop mode, the two arrows below adjust the sample
length by half length or double length increments respectively.
7
To delete the sample and start recording a new one, click  [REC]
again.
8
The sample is stored on a fixed memory location for the duration of a
session and can be selected and played with the controller just like the
preset samples.
9
For each sample cell, there is an sample options menu available by
clicking the selector button [
[Loop]: sets the sample to loop mode

[Match pitch]: matches the sample to the pitch of the title on the other

deck
[BeatLock]: matches the sample to the beat of the title on the other deck

even if you are scratching on the other deck
[Sync on]: 1 beat, ½ beat, ¼ beat

[AutoPlay]: the sample begins playing as soon as the volume is adjusted

[Write Protected] the sample cannot be recorded over


8.4 Scratch effects

Press the button [SCRATCH] (LED lights up) to switch on the scratch function for the [JOGDIAL]. Turn the
[JOGDIAL] back and forth to create scratch effects. To switch off the function press the button [SCRATCH]
once again (LED extinguishes).

8.5 Stutter effects

The cue points stored with the buttons [HOT CUE 1] to [3] as well as the button ► [PLAY] can be used for
creating stutter effects. Shortly press one of the buttons to create a stutter effect.
].
65/72 00061967.DOC, Version 1.1