Starting Use; Switching Off The Appliance; Storage; Repacking For Private Transport Purposes - Rowi HIT 2000/2/2 F Premium Originalbetriebsanleitung

3.2

Starting use

The appliance can be put into operation after removing the packaging. Proceed as follows
for this:
1. Make sure that the ON/OFF switches (see Fig. 1, No. 2) are switched off.
2. Then connect the infrared patio heater to an earthed socket protected with an earth-
leakage circuit breaker.
The radiant heater from ROWI has two heating arcs that can be selected separately, each
1000 Watt. To switch on, turn one of the two switches on the upper end section of the
standpipe; the red lamp lights up. The following applies here:
Position
I
II
I + II
Tab. 3: Switch position
When first put into operation or after a longer period without heating
a short-term odour can arise.
3.3

Switching off the appliance

1. Press the switch/switches downwards to switch off the device.
2. Pull the power plug out of the socket.
Wait until the appliance has cooled down before covering it or putting it away.
3.4

Storage

Protect the infrared patio heater from dust, dirt and insects. Cover
the patio heater with a sheet so that it is protected from impurities and damage or malfunc-
tions caused by this.
3.5

Repacking for private transport purposes

Always pack the appliance in its original packaging for transportation to prevent transport
damage.
Watt
1000 W
1000 W
2000 W
33/44