Cleaning And Maintenance; Safety Measures; Maintenance; Troubleshooting - Rowi HIT 2000/2/2 F Premium Originalbetriebsanleitung

4.

Cleaning and Maintenance

4.1

Safety measures

P Always pull the mains plug out of the socket before servicing the appliance.
P Only begin the maintenance or repair work once the infrared patio heater has cooled
down.
P Do not use halogen solvents for cleaning, as this could otherwise cause chemical
reactions.
4.2 Cleaning
The infrared patio heater should be covered after each use to prevent contamination by
impurities.
Do not cover the appliance until it has fully cooled down.
If the appliance has nevertheless become dirty, observe the following notes during cleaning:
P Only clean the infrared patio heater when cooled down.
P Pull out mains plug before any work.
P Only clean the infrared patio heater with a dry, soft cloth. Never use sharp and/or
abrasive cleaning agents.
4.3

Maintenance

Note that only original parts may be used for repair and maintenance work. Contact the
ROWI Service Center if need be (see Chapter 6).
The device does not
function.
4.4

Troubleshooting

Fault
The appliance is
connected to a socket,
but the heating tubes
do not light up.
No voltage
Possible cause(s)
The appliance is not swit-
ched on.
34/44
Check the socket and fuse.
Check whether the mains
plug, also the one inside the
standpipe and burner head, is
Remedy
correctly plugged in.
Check the setting on the ON/
OFF switch and press the
switch upwards to switch on
the device if need be. A red
pilot lamp lights up.