Sleep Function - Carrier 51QPD009N/PC-09HPPD Installationshandbuch

4. OPREATION
FOLLOW ME Function*
When the Follow Me function is activated, the remote display is actual temperature at its location. And the remote controller will send
this signal to the unit every 3 minutes interval until press the FOLLOW ME button again.
NOTE:
The Follow Me function is not available under DRY and FAN mode.
IONIZER Function*
Negative ions are added to the air to simulate the effects of forests and waterfalls on humans.

SLEEP FUNCTION

When selected, the set temperature will increase (cooling) or decrease (heating) by 1°C per 30 mintues for the first 1 hours. Thereafter
it keeps this new temperature for 7 hours before quiting the SLEEP mode.
This operation saves energy and improves night time comfort by synchronising with the body's metabolism.
Compressor Delay
At start-up, a time delay of 3 to 4 minutes protects the compressor.
Cold Draft Prevention
To avoid uncomfortable drafts in heating mode, the indoor unit is preheated before the fan starts. This delay should only last a few
minutes.
Auto Defrost
Ice develops on the outdoor unit in heating mode. To defrost this ice, the indoor fan stops for a few minutes before heating continues.
Auto Restart*
The unit will automatically restart after a power interruption. Previous user settings are all recovered.
Water Tray Full Protection Function
When the LED display shows "P1", it means the bottom tray is full of water and needs draining. The unit will stop automatically and can
not be restarted until the water is drained.
1) Move the unit to a drain location.
2) Remove the bottom tray drain outlet cover and plug.
3) After the water is fully drained, put back the plug and cover.
4) Switch on the unit until "P1" disappears.
NOTE:
If "P1" continues to display, unplug the unit and call for qualified service personnel for assistance.
[*] Model dependent
water tray plug
– 10 –
G B