Dometic RMD10 Serie Montageanleitung Seite 19

RMD10
4.4 Installing the ventilation grill
I
NOTE
Use exclusively original Dometic ventilation grills to ensure safe opera-
tion.
No. in
fig. 9, page 8
1
2
3
4
➤ Seal the installation frame to make the connection waterproof (fig. 0, page 8).
➤ Insert the installation frame and screw it down tightly (fig. a, page 8). Use all the
fixing holes for this.
➤ Insert the ventilation grill as shown (fig. b, page 9).
4.5 Installing condensation drain
I
NOTE
• Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
• Condensation must be drained with a constant slope.
Install the condensation drain as follows:
Variant 1
➤ Run the condensation hose from the refrigerator through an opening in the floor
which goes outside under the vehicle.
Variant 2
➤ Attach the condensation hose directly to the fitting intended for it on the ventila-
tion grill (fig. 9 4, page 8).
EN
Description
Slider
Ventilation grill
Installation frame
Fastening for condensation drain
Installing the refrigerator
19