Lamp Information - HAPRO Proline 28 C SLi Anleitung

Lamp information

The lamps listed below are those that are installed as standard equipment at the factory . These standard lamps have been selected for
optimal tanning results and to match the UV classifi cation of your tanning unit . We recommend that when you replace a lamp you only
use lamps of the type currently installed in your tanning unit and which are listed in the table below and on the identifi cation plate . If you
choose to install a diff erent type of lamp, you must only use lamps that are marked with an equivalent code which indicates that the UV
component falls within the equivalence range listed on the identifi cation plate .
Note: The equivalent code is only applicable to low-pressure fl uorescent lamps .
Lamps
maxlight L 100W-R CE III
maxlight 80W-R CE III
maxlight 100W-R CE 0,3
maxlight 100W-R CE III
maxlight 100W-R High Intensive
maxlight L 100W-R High Intensive
maxlight 80W-R High Intensive
Power facial tanner Filter 1
300W SPS
Note: The total erythema is limited to 0 .3 W/m² for all UV types within the EU .
Model : XXXXX
Type : XXXXXXXX
Serial number : XXXXXXXXXX / 3
Rated voltage : XXXXXXXX
Rated power input : XXX W
With Airco : XXX W
30 x maxlight 160W-R CE III
160-R-(21-28)/(2,2-3)
22 x maxlight XL180W-R CE III
180-R-(21-28)/(2-2,6)
22 x maxlight HP 500W S or maxlight HP 500W D
Main Filter: SPS (Art. nr. 15691) Ballast: 320W
UV type 3 (Total Erythema output limited at 0,3W/m
Manufactured by: Hapro International B.V.
PO Box 73
4420 AC Kapelle, Netherlands
Art nr equivalent code
12806 100-R-(22-29)/(2,7-3,7)
12792 80-R-(20-26)/(2,2-3)
16997 100-R-(18-24)/(2-2,6)
12797 100-R-(17-22)/(2,1-2,9)
12801 100-R-(38-50)/(5,1-6,9)
12808 100-R-(46-61)/(5,8-7,8)
13603 80-R-(49-65)/(6,7-9,1)
Filter 2
Diamant
Example:
On the example identifi cation plate the equivalent codes for the installed canopy and bench lamps are
circled .
The equivalent code for the canopy is 160-R-(21-28)/(2 .2-3)
160 = the wattage of the lamp
R = the refl ector type
(21-28) = the equivalence range for the total eff ective erythema
(2 .2-3) = the equivalence range for the NMSC ratio
If you intend to install a new lamp, the wattage and refl ector type must always match the equivalent code
on the identifi cation plate . The eff ective erythema and NMSC ratio must also match the specifi ed range .
You may only use a lamp other than the recommended type if all of these criteria are met . You must also be
aware that:
)
3
a . The tanning unit is likely to be less eff ective in terms of tanning performance .
b . The circuit protection for your tanning unit must be adapted because the electrical current
consumption will have changed .
c . The UV classifi cation no longer matches the original classifi cation shown on the identifi cation plate .
d . We will not necessarily honour warranty claims arising from the use of lamps other than those we
recommend, because the technical operation of your tanning unit might be aff ected .
UV type (EU countries)
3
3
2
3
May not be used
May not be used
May not be used
UV type (EU countries)
3
UV type (non-EU countries)
3
3
3
3
5
5
5
UV type (non-EU countries)
3
5