Lamp Information - HAPRO COLLAGEN SUN 26/5 Anleitung

Lamp information

The lamps listed below are those that are installed as standard equipment at the factory. These standard lamps have been selected for
optimal tanning results and to match the UV classi cation of your tanning unit. We recommend that when you replace a lamp you only
use lamps of the type currently installed in your tanning unit and which are listed in the table below and on the identi cation plate. If you
choose to install a di erent type of lamp, you must only use lamps that are marked with an equivalent code which indicates that the UV
component falls within the equivalence range listed on the identi cation plate.
Note: The equivalent code is only applicable to low-pressure uorescent lamps.
Lamps
maxlight Collatan 100W R
maxlight Collatan 100W LR
Seecret 25W R
Note: The total erythema is limited to 0.3 W/m for all UV types within the EU.
Model : XXXXX
Type : XXXXXXXX
Serial number : XXXXXXXXXX / 3
Rated voltage : XXXXXXXX
Rated power input : XXX W
With Airco : XXX W
14 x maxlight Collatan100W L R
100-R-(18-24)(2,8-3,8)
5 x Seecret 25W R
12 x maxlight XL180W-R CE III
180-R-(17-22)/(3-4)
UV type 3 (Total Erythema output limited at 0,3W/m
Manufactured by: Hapro International B.V.
PO Box 73
4420 AC Kapelle, Netherlands
Art nr equivalent code
28082 100-R-(17-22)/(3-4)
28083 100-R-(18-24)/(2,8-3,8)
22506
Example:
On the example identi cation plate the equivalent codes for the installed canopy and bench lamps are
circled.
The equivalent code for the canopy is 100-R-(18-24)/(2,8-3,8)
100 = the wattage of the lamp
R = the re ector type
(18-24) = the equivalence range for the total e ective erythema
(2,8-3,8) = the equivalence range for the NMSC ratio
If you intend to install a new lamp, the wattage and re ector type must always match the equivalent code
on the identi cation plate. The e ective erythema and NMSC ratio must also match the speci ed range.
You may only use a lamp other than the recommended type if all of these criteria are met. You must also be
aware that:
)
3
a. The tanning unit is likely to be less e ective in terms of tanning performance.
b. The circuit protection for your tanning unit must be adapted because the electrical current
consumption will have changed.
c. The UV classi cation no longer matches the original classi cation shown on the identi cation plate.
d. We will not necessarily honour warranty claims arising from the use of lamps other than those we
recommend, because the technical operation of your tanning unit might be a ected.
UV type (EU countries) UV type (non-EU countries)
3 3
3 3
3 3
5