Husqvarna TS142L Bedienungsanweisung Seite 23

• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around
the transaxle fan and cooling fins.
• Examine the cooling fan to make sure the fan
blades are clean and not damaged.
To examine the transaxle pump fluid
• Make sure that the transaxle pump fluid does not
leak.
• Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.
To adjust the front wheel toe-in and camber
The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are
not adjustable.
• Speak to an approved service center if the
factory-set front wheel toe-in or camber is
damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover
on its sides. Tilt the engine cover in the direction
of the engine and lift it to remove it from the
product.
4. Install in the opposite sequence.
To replace the drive belt
1. Park the product on a level surface and engage
the parking brake. Refer to
on page 16 .
2. Remove the cutting deck. Refer to
and install the cutting deck on page 25 .
1707 - 001 - 10.09.2021
A
To stop the product
To remove
3. Remove the drive belt from the pulley (A) and the
clutch pulley (B).
C
B
A
D
4. Remove the drive belt from the engine pulley (C)
on the engine shaft.
5. Remove the drive belt from the rear axle pulley
(D) and the belt tension pulley (E).
6. Remove the drive belt from the product.
7. Install a new drive belt in the opposite sequence.
To adjust the motion control lever
The motion control lever is correctly adjusted from
factory. Only adjust the motion control lever if the
product moves when the motion control lever is in
the neutral position.
1. Loosen the adjustment bolt (A) and tighten it
lightly.
E
B
C
A
23