To Replace The In-Line Fuel Filter - Husqvarna TS142L Bedienungsanweisung

• Make sure that the grass screen, the cooling fins,
and other external surfaces of the engine are
clean at all times.
• After each interval of 100 hours of operation
(more often in extremely dusty and dirty
conditions), remove the blower housing and
other parts of the engine cooling system. Clean
the cooling fins and external surfaces as
necessary. Make sure that the engine cooling
system parts are installed correctly.
To replace the spark plugs
The spark plug type and clearance (gap setting) are
Technical data on page 37 .
shown in
• Replace the spark plugs at the start of each
cutting season or after each interval of 100 hours
of operation.

To replace the in-line fuel filter

Note:
Replace the in-line fuel filter every year at
minimum.
Replace the in-line filter if it becomes clogged and
stops the flow of fuel to the carburetor.
1. Let the engine cool.
2. Remove the in-line fuel filter (B) and seal the fuel
line sections with plugs.
3. Put the new in-line fuel filter in position in the fuel
line with the arrow pointing to the carburetor.
4. Make sure that there are no fuel line leaks and
that the clamps (A) are in the correct position.
5. If you spill, immediately clean the product.
B
30
To remove the air from the
transmission
To keep high performance, remove the air in the
transmission before you operate the product for the
first time.
If you replace the transmission, remove the air in the
new transmission before operation.
1. Put the product safely on a level surface that is
clear and open with the engine off and the
parking brake set.
2. Put the freewheel control in the disengaged
position to disengage the transmission. (See
Transportation on page 35 ).
3. Sit in the tractor seat and start the engine. After
the engine is running, move the throttle control to
the slow position and then disengage the parking
brake
4. Push the forward drive pedal to the full forward
position, hold for five (5) seconds and then
release the pedal. Push the reverse drive pedal
to full reverse position, hold for five (5) seconds
and then release the pedal. Do this procedure
three (3) times.
Note:
movement of the drive wheels.
5. Stop the engine and set the parking brake.
6. Put the freewheel control in the engaged position
to engage the transmission. (See
A
on page 35 in this section of manual.)
7. Sit in the tractor seat and start the engine. After
the engine is running, move the throttle control to
half (1/2) speed. Disengage the parking brake.
8. Operate the product forward for approximately 5
ft (1.5 m) then rearward for 5 ft (1.5 m). Do this
procedure three times.
CAUTION:
Do not engage or
disengage freewheel lever while the
engine is running.
During this procedure, there can be
1707 - 001 - 10.09.2021
Transportation