Bartscher 900 K4 series Bedienungsanleitungen Seite 51

Safety Thermostat (figg.10, 18- pagg.5, 6)
To substitute the thermostat, it is necessary to remove the knobs, the drip pan and the control panel,
as shown in figure 14; then the bulb situated in the front part of the appliance, may be taken out,
removing the fixing plate of the bulb (1) by unscrewing the appropriate screw (2). Next, it is
necessary to unscrew in sequence, the pipe union of the pipe which goes to the burner (3), the pipe
union of the pilot burner pipe (4), the thermocouple (5) and finally, the pipe union of the ramp (6).
Then substitute the part.
Thermocouple
To substitute the thermocouple of the griddle plate, it is necessary to remove the knobs, the drip pan
and the control panel. It is then necessary to unscrew the fitting of the thermocouple on the cock
and the one on the pilot unit, then substitute the part.
Elements (figg.10, 16 – pagg.5, 6)
To substitute the elements, firstly it is necessary to remove the knobs, the drip pan and the control
panel, as shown in figure 10; then unscrew the fixing screws of the covering, remove the covering
and disconnect the element to be substituted, then remove it.
Electric components of the electric griddle plate (fig. 17- pag.6)
For the replacement of the selector (2), the thermostat (3), the lamps (1), the main terminal board
(5), the safety thermostat (6) of the electric griddle plate, it is necessary to unscrew the control
board (as shown at fig.10 on pag.6), remove it, then disconnect the electric cables of the component
and replace it. After the replacement, connect the electric cables following the instructions of the
wiring diagram.
Information for electrical and electronic devices used in EU countries
According to EU directives, devices marked with the following symbol , may not be disposed
of together with normal household waste.
To dispose of your used device, please use the locally available differentiated collection system or
consult your retailer when you buy an equivalent product.
By actively using the provided collection systems, you are contributing to the reuse, recycling and
enhancement of electrical or electronic devices and protecting the environment and health.
Abusive product disposal is punishable by law in accordance with current legislation.
WHEN SUBSTITUTING, ONLY ORIGINAL SPARE PARTS SUPPLIED BY THE
MANUFACTURER MUST BE USED. THE OPERATION MUST BE CARRIED OUT BY
AUTHORIZED PERSONNEL.
ATTENTION! In the event that components of the gas installation are substituted, it is
necessary to check for tightness and the correct functioning of the various parts.
THE MANUFACTURER RESERVES THE RIGHT TO WITHOUT NOTICE MODIFY
THE FEATURES OF THE APPLIANCES DESCRIBED IN THIS MANUAL.
Pag. 51/68