Bartscher 900 K4 series Bedienungsanleitungen Seite 48

Gas fry-top (fig. 14 – pag.6)
To light the burner of the fry-top, proceed in the following way:
- turn the knob (1) from the off position
- press down to the bottom;
- push the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the slit in the control panel;
- light the main burner, positioning the knob in one of the eight possible positions, choosing the
one most suited to the type of cooking desired, considering that they correspond indicatively to
the temperatures shown below:
Position [N°]
Temperature [°C]
To put out the main burner, it is necessary to turn the knob to the right into the on position
put out also the pilot, turn the knob again into the off position .
Electric fry-top (fig. 15 – pag.6)
To light the fry-top, proceed in the following way:
- Turn the knob (1) of the thermostat into the position which corresponds to the cooking
temperature desired; the two lights come on, the green light stays on all the time to show that
there is tension, whilst the orange one goes off as soon as the hotplates reach the desired
temperature.
To turn off the hotplate turn the knob into the 0 position.
ATTENTION! Only use the appliance under surveillance. Never let the hotplates function
with nothing on them.
Abnormal functioning
If for any reason, the appliance does not start up or stops working during use, check that the
energy supply and the control knobs are set correctly; if all is regular, call customer service.
Some problems and possible solutions
Problem
The pilot burner does not light on
INSTRUCTIONS FOR USE
into the on position
1 2 3
150 175 200
- Check that gas inlet pressure is the same as that shown in
table at page 29
- Check that the nozzle of pilot burner is not blocked
- Check that the igniter plug is well fixed and connected
- Check that the igniter plug is intact
- Check that the igniter cable is intact
- Check that the piezoelectric igniter is intact and
functions correctly
- Check the gas valve
Pag. 48/68
;
to light the pilot burner;
4 5 6
225 250 275
Possible solution
7 8
300 325
, to