Configuring The Network; Configuring The Ipv4 Address - Sony ODS-L30M Bedienungsanleitung

Configuring the Network

After configuring the IPv4 address in the display on the
front panel of the unit, connect the unit to the computer on
which the Web browser is installed, and configure the
unit's settings and check its status via the Library
Maintenance Web UI.

Configuring the IPv4 Address

The IP address, subnet mask, default gateway settings are
required. Network 1 is configured for DHCP by factory
default. Network 2 is configured with the following
settings.
IP address: 192.168.1.10
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
Use the display and the buttons on the front panel of the
unit to configure the network settings.
1
Press the MENU button.
The menu appears in the display.
2
Use the J and j buttons to select [Setup], and press
the ENTER button.
The [Setup] screen appears.
3
Use the J and j buttons to select [Network], and
press the ENTER button.
The [Network] screen appears.
4
Use the J and j buttons to select [Network 1], and
press the ENTER button.
The [Network1] screen appears.
54
Configuring the Network
5
Use the J and j buttons to select [IPv4 Setting], and
press the ENTER button.
The following screen appears. An asterisk (*)
indicates the current setting. To configure the IPv4
address, this setting must be set to [Enabled]. If the
setting is already set to [Enabled], proceed to step 8.
6
Press the ENTER button to change the setting.
The selection screen (i.e., screen with the cursor (>))
appears. You can change the setting in this screen.
7
Use the J and j buttons to select [Enabled], and press
the ENTER button.
The confirmation screen (i.e., screen without the
cursor (>)) appears.
8
Check that [Enabled] is selected, and press the j
button.
The following screen appears.
9
Press the ENTER button to display the selection
screen.
10
To use a static IP address, use the J and j buttons to
select [Static], and press the ENTER button.
Note
To use the DHCP, use the J and j buttons to select
[Auto], press the ENTER button, and then proceed to
step 17.