Sony ODS-L30M Bedienungsanleitung Seite 61

Message Description
I/E STATION The I/E STATION button was pressed while the I/E station was being accessed.
BUSY Wait for the I/E STATION indicator to light green or orange before pressing the I/E STATION button.
I/E STATION Unlocking of the I/E station failed.
NOT UNLOCKED Press the I/E station all the way into the unit so that it is fully inserted, and then try pressing the I/E
STATION button again.
I/E STATION HALF- The I/E station is not fully inserted.
CLOSED Press the I/E station all the way into the unit so that it is fully inserted, and then try pressing the I/E
STATION button again.
PUSH I/E STATION The I/E station has been in a state of incomplete insertion for at least 15 seconds.
Press the I/E station all the way into the unit so that it is fully inserted.
REMOVE CARTRIDGE Import processing for the I/E station cannot be performed due to the presence of a cartridge in the
FROM CARRIER carrier.
Move the cartridge from the carrier to an empty slot via the [Move Cartridge] tab of the Library
Maintenance Web UI.
ERROR CALIBRATION Carrier adjustment failed due to the presence of a cartridge in the carrier. Consult your local Sony
REMOVE CARTRIDGE representative.
FROM CARRIER
I/E STATION An I/E slot movement prompt was issued while the I/E station was open.
OPENED Close the I/E station, or check the application controls.
UNIT CONFIG CHANGE A change in the unit configuration was detected.
REQUEST Consult your local Sony representative.
DIAGNOSTIC LIBRARY Library diagnostics are required.
REQUEST Consult your local Sony representative.
EXPORTED CARTRIDGE A cartridge was exported to the I/E station of the displayed unit. Remove the cartridge from the I/E
IN I/E STATION station as required.
UNIT <unit number>
I/E STATION UNLOCKED The I/E station of the displayed unit is unlocked. Open the I/E station, exchange the cartridge, and
UNIT <unit number> then close the I/E station.
BULK IMPORT MODE [Bulk Import] is set to "ON" on the [Import/Export Cartridge] tab of the Library Maintenance Web UI.
After cartridge import processing is finished, always set [Bulk Import] to "OFF."
61
Messages