Specifications; Specific Safety Rules - Makita HR3200C Betriebsanleitung

ENGLISH
1. Switch trigger
2. Lamp
3. Adjusting dial
4. Quick change chuck for SDS-plus
5. Change cover
6. Chuck cover
7. Spindle
8. Quick change drill chuck
9. Lock button
10. Pointer

SPECIFICATIONS

Concrete
Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to rotary
hammer safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
6
Explanation of general view
11. Change lever
12. Power-ON indicator lamp (green)
13. Service indicator lamp (red)
14. Side grip
15. Bit shank
16. Bit grease
17. Bit
18. Depth gauge
19. Clamp screw
20. Dust cup
Model
Tungsten-carbide tipped bit
Core bit
Steel
Wood
-1
)
Blows per minute
Overall length
Net weight
Safety class
HR3200C
2. Use auxiliary handles supplied with the tool. Loss
END201-4
of control can cause personal injury.
3. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
ENE044-1
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
ENF002-1 6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident.
Check tightness of screws carefully before
operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
GEB007-2
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
21. Blow-out bulb
22. Chuck adapter
23. Keyless drill chuck
24. Sleeve
25. Ring
26. Screws
27. Connector
28. Crank cap cover
HR3210C
32 mm
90 mm
13 mm
32 mm
315 - 630
1,650 - 3,300
398 mm
4.4 kg 4.8 kg
/II
HR3210FCT
424 mm
5.0 kg