Connecting The Usb Device To The Client - SEH myUTN-2500 Schnellinstallationsanleitung

Connecting the USB Device to the Client

To use a USB device, a connection is established between the client and the USB
port of the UTN server to which the USB device is connected.

All provisions (driver installation, etc.) necessary to operate the USB device
locally (i.e. connected directly to the client) have been met on the client. Ide-
ally, the USB device has been connected and operated on the client locally
according to the instructions of the manufacturer.

The USB port is not connected to another client. A USB device that was made
available by the UTN server can only be used by one network participant at a
time.
1. In the selection list, select the port.
2. From the menu bar, select Port – Activate.
 The connection will be established.
Important:
Close the connection to the USB port when you no
longer need the attached USB device. To do this, select
Port – Deactivate from the menu bar.
Quick Installation Guide [en] 12