Specifications; Standard Accessories; Prior To Operation - Hitachi vtv-18 Bedienungsanleitung

English

SPECIFICATIONS

Model
Voltage (by areas)*
Power input
Speed change
No-load speed
Capacity: Steel
Concrete
Weight (w/o cord)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Chuck Wrench ........................................................... 1
(2) Side Handle ............................................................... 1
(3) Depth Stopper ........................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Drill Bit for concrete
O.D. Length
6.5mm 100mm
8.0 100
9.5 120
10.0 120
12.0 160
13.0 160
14.3 160
16.0 160
18.0 300
Optional accessories are subject to change without
notice.
APPLICATIONS
By combined action of ROTATION and IMPACT:
Boring, holes in concrete, marble, granite, tile and
similar materials.
By ROTATION only:
Boring holes in metals, wood and plastics.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
4
VTP-18
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
1 2
1050/min 1800/min
13mm 8mm
18mm 10mm
will start operating immediately, which could cause
serious injury.
3. Extension cord
When the work area is not near a power source.
Use an extension cord of sufficient thickness and
rated capacity. The extension cord should be kept
as short as possible.
4. Fitting the Drill Bit:
Fit the drill bit into the chuck and use the chuck
wrench to secure it, tightening the chuck by each of
the three holes in turn.
5. Selecting the appropriate drill bit:
Code No.
When boring concrete or stone:
Use the drill bits specified in the Optional
931851
Accessories.
931852
When boring metal or plastic:
931853
Use an ordinary metalworking drill bit.
When boring wood:
931854
Use an ordinary woodworking drill bit. However,
971704
when drilling. 6.5mm or smaller holes, use a
metalworking drill bit.
931855
6. High-speed/Low-speed changeover:
931776
Prior to changing speed, ensure that the switch is in
971670
the OFF position, and the drill has come to a
complete stop. To change speed, depress the shift
950496
lock and slide it in the appropriate direction, as
indicated by the arrow in Fig. 1. The numeral "1"
engraved in the drill body denotes low speed, the
numeral "2" denotes high speed.
7. IMPACT to ROTATION changeover: (Fig. 2)
The Impact Drill can be switched from IMPACT
(impact plus rotation) to ROTATION (rotation only)
by simply turning the change ring.
When boring concrete, stone, tile or similar hard
materials, turn the change ring fully clockwise when
viewed from the drill chuck side. The drill head
impacts against the material while continuing to
rotate.
When boring metal, wood or plastic, turn the change
ring fully counterclockwise. The drill simply rotates
as an ordinary electric drill.
CAUTION
Do not use the Impact Drill in the IMPACT function
if the material can be bored by rotation only. Such
action will not only reduce drilling efficiency, but
may also damage the drill tip.
When changing over, ensure that the change ring is
turned as far as it will go.
VTV-18
640W*
1
0 – 1050/min
13mm
18mm
2.3 kg
2
0 – 1800/min
8mm
10mm