Battery Removal/Installation - Hitachi dn 10dy Bedienungsanleitung

3. Minus driver bit
a
0.8 mm
1 mm
a
4. Drill bit for steel
Diameter, 2 mm, 5 mm, 6 mm.
5. Drill bit for wood
Diameter, 10 mm, 13 mm.
Optional accessories are subject to change without no-
tice.
APPLICATIONS
Driving and removing of wood screws, tapping
screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
Table 1
Blinks
Before
(RED)
charging
While Lights
(RED)
charging
Blinks
Charging
(RED)
complete
Charging
Flikers
impossible (RED)
Charging Lights
impossible (GREEN)
(UC14YF/UC14YF2 only)
Screw size
4 mm
5 – 6 mm
Indications of the lamps
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Lights continuously
CHARGING
Before using the power tool, charge the battery as fol-
lows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
<UC12Y>
Position the battery so that the nameplate faces
toward the ventilation slots of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
<UC14YF/UC14YF2>
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
CAUTION
If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause or problems in the charger such
as a deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light con-
tinuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
English
Malfunction in the
battery or the charger
The battery tempera-
ture is high, making
recharging impossible.
5