Installation Instructions; Information About Gas Cooktops Optima Series; Laws, Regulations And Technical Directives To Be Complied With - Diamond G77/4F7T-N Handbuch

2.

INSTALLATION INSTRUCTIONS

Installation and any transformation for using other types of gas, must be performed by qualified technicians according
to the law in force.
See technical data tables.
WARNINGS:
Should the unit be installed against a wall, the latter must be heat resistant to temperatures of 80°C and must be fireproof.
Before proceeding with the installation, remove the protective plastic film from the relevant parts, eliminating any adhesive
residues with an appropriate cleaning product suitable for stainless steel.
Install the unit in a horizontal position; its correct levelling will be achieved by rotating the adjustable feet.
If the unit is installed by itself, it is advisable to fasten it to make its stability safer.
2.1

INFORMATION ABOUT GAS COOKTOPS OPTIMA SERIES

This manual applies to our Gas Cooktops OPTIMA Series, Type A and B , Category II (Natural Gas and L.P.G.).
II
1
See table 1.1.
The label according to EN437 and EN203-1-2 regulations, is located:
a) on the Top units, at back or inside.
Example for Italy label: Category II
2H3÷
Pe= Incoming Pressure
Pi= Nozzle Pressure
MK
20,37,50
2.2

LAWS, REGULATIONS AND TECHNICAL DIRECTIVES TO BE COMPLIED WITH

The following indications should be observed during installation:
- Accident and fire regulations in force
- Prescriptions by the Gas Supply Company, which should issue an authorisation before installation.
- Instructions for the "Installation of gas equipment"
- Instructions for the "Installation of electrical equipment"
- Prescriptions by the Electrical Supply Company
- Hygienic regulations.
GB
- 14 -