Automatic Updates; Further Functions And Notes - Canton Smart Soundbar 10 Kurzanleitung

AUTOMATIC UPDATES

After you connect the Soundbar 10 to the network, future firmware updates will
automatically be performed on your Soundbar 10. After the initial setup and each
time it is turned on, Soundbar 10 looks for an update and installs it, if available. The
LED flashes green / red during the update and the display shows „UPDATING".
During this time, the system is not operational.
Attention:
• Do not disconnect the Soundbar 10 from the power supply during an update
process.

FURTHER FUNCTIONS AND NOTES

The Soundbar 10 contains a multitude of other great functions. All settings can be
found in the detailed instruction manual. These can be found under:
www.canton.de/manual/soundbar10
Technichal Data -
Power supply
– Operating voltage 100 – 240V~
– Operating frequency 50 / 60Hz
– Power consumption ECO Standby 0.40 W
– Power consumption NSB Standby ca. 1.9W (Factory setting)
– Power consumption LSB Standby ca. 6.6W
– Power consumption AUT Standby ca. 6.6W
– Power consumption MAN Standby ca. 4.2W
– Power consumption in idle mode (no output signal) ca. 9.8W
– Power consumption maximal ca.150W
Smart Soundbar 10
Bluetooth
®
– Bluetooth Standard 4.0 (A2DP)
®
– Wireless range up to 10 m
– Frequency response 2400–
2483.5 MHz (2.4 GHz ISM Band)
– Max. transmission power 10 mW
(+10dBm)
Ambient temperature:
– Minimum 5 °C (41 °F)
– Maximum 35 °C (95 °F)
English
3 3 9