Room Thermostat With Actuator; Operation; Illustr. 11: Install Room Thermostat With Actuator - oventrop Unibox TQ RTL vario Betriebsanleitung

Operation

(1)
Remote control
(2) Control piston
4. Position the cover plate on the "Unibox TQ
RTL vario".
The cover plate is not contained in
the extent of supply and must be
acquired separately (see 4 on page
32).
7.5 Room thermostat with
actuator
1. After completing all building work, remove
the "Unibox TQ RTL vario" protection
cover.
2. Remove the protection cap.
3. Screw the actuator (see Illustr. 11 on page
36 (2)) onto the valve. Pass the cable
through the bore hole in the wall box unit
(see 6.1 on page 33).
Further information can be obtained
from the operating instructions
supplied with the actuator.
1
Illustr. 11: Install room thermostat with actu-
ator
(1)
Room thermostat
36
(2)
Actuator
4. Install the room thermostat in accordance
with the corresponding operating instruc-
tions.
5. Position the cover plate on the "Unibox TQ
RTL vario".
8. Operation
Set the fluid temperature of the surface
temperature balance circuit on the handwheel
inside the "Unibox TQ RTL vario" (see 3.4.1 on
page 31). Set the room temperature on the
thermostat correspondingly.
2
Unibox TQ RTL vario
The cover plate is not contained in
the extent of supply and must be
acquired separately (see 4 on page
32).
102273680-V01.07.2019