Optional Accessories - Makita GA7062 Betriebsanleitung

Operation with wire wheel brush
Optional accessory
CAUTION:
Check operation of wire wheel brush
by running tool with no load, insuring that no one is
in front of or in line with the wire wheel brush.
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
ALWAYS use guard with wire
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
► Fig.21: 1. Wire wheel brush
Unplug tool and place it upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire wheel
brush onto spindle and tighten with the wrenches.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
wire wheel brush. It may lead to premature breakage.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended for use with your Makita tool spec-
ified in this manual. The use of any other accessories or attachments might present a risk of injury to persons.
Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
► Fig.24
1
2
3
4
5
6
7
8
9
10
11
12
13
14
-
-
NOTE: *1 Only for tools with M14 spindle thread.
NOTE: *2 Do not use Super flange and Ezynut together.
NOTE: *3 In some European countries, when using a diamond wheel, the ordinary guard can be used instead of the
special guard covering the both side of the wheel. Follow the regulations in your country.
NOTE: *4 Use Inner flange 78 and Outer flange 78 together. (Australia and New Zealand only)
NOTE: Some items in the list may be included in the tool package as standard accessories. They may differ from country to country.
Side grip / Loop handle
Wheel guard for depressed center wheel / flap disc / wire wheel brush
Inner flange / Super flange *1*2
Depressed center wheel / Flap disc
Lock nut / Ezynut *1*2
Wheel guard for abrasive cut off wheel / diamond wheel *3
Inner flange 78 (Australia and New Zealand only) *4
Abrasive cut-off wheel / Diamond wheel
Outer flange 78 (Australia and New Zealand only) *4
Sanding lock nut
Wire wheel brush
Wire cup brush
Lock nut wrench
Dust cover attachment
13 ENGLISH
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks may result.
Air vent cleaning
The tool and its air vents have to be kept clean. Regularly clean the
tool's air vents or whenever the vents start to become obstructed.
► Fig.22: 1. Exhaust vent 2. Inhalation vent
NOTE: Do not loosen the screw on the name plate
cover. Otherwise the cover may be opened accidentally.
► Fig.23: 1. Screw
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Rubber pad
Abrasive disc