Management; Snmp; Tabelle 86: Cli "Snmp" Configuration - WAGO 852-1813 Handbuch

WAGO-Industrial-Switches
852-1813 Lean-Managed-Switch
10.2.6

Management

10.2.6.1

SNMP

Tabelle 86: CLI "SNMP" Configuration

Node
enable
configure
configure
configure
configure
configure
configure
Example
L2SWITCH#configure terminal
L2SWITCH(config)#snmp enable
L2SWITCH(config)#snmp community public rw trusted-host 192.168.200.106/24
L2SWITCH(config)#snmp trap-receiver 192.168.200.106 v2c public
L2SWITCH(config)#snmp system-contact IT engineer
L2SWITCH(config)#snmp system-location Wago
Command
show snmp
snmp community STRING
(ro | rw) trusted-host
IPADDR
snmp (disable | enable)
snmp system-contact
STRING
snmp system-location
STRING
snmp system-name
STRING
snmp trap-receiver
IPADDR VERSION
COMMUNITY
Description
This command displays the SNMP configurations.
This command configures the "SNMP Community"
name.
This command disables/enables SNMP on the
switch.
This command configures contact information for the
system.
This command configures the location information for
the system.
This command assigns a name to the system.
This command sets up the trap receiver's
configurations, including the IP address, version (v1
or v2c) and "Community."
Anhang 191
Handbuch
Version 1.0.0